![]() ![]() Added support for Rollback of Controller Firmware through iDRAC/LC Fixed M.2 disk failure when medium error is present Enhanced/ Added MVCLI events for command timeout Fixed a behavior where rebuild will not be proceed during error handling condition Fixed a behavior where ESXi host results in PSOD due to unexpected I/O timeout Fixed a behavior where BOSS-S1 boot partition becomes inaccessible Fixed a behavior where BOSS-S1 Management path will not respond to Management commands Fixed a behavior where ESXi Host goes unresponsive ![]() Fixed a behavior of BOSS-S1 firmware incorrectly marking M.2 drive offline/failed ![]() 'ahcich15: stopping AHCI engine failed' 'ahcich14: stopping AHCI engine failed' ![]() Works and detects all disks, but gives errors about: When CLI is running, default temporary fileĭirectory & permission in Linux and ESXi Operating Fixed an issue where system will hang duringīoot when PERC is in HBA mode with BOSS-S1 Pass23 at ahcich16 bus 0 scbus19 target 0 lun 0 Detects a 'pass23', but no disk devices: 'ahcich16: stopping AHCI engine failed' I have had M.2 drive go "offline" for me at 2008/A01-firmware so that's why I tried the later versions.Ī summary of the (Dell) firmware fixes and my test results:Įnhancement: Added support for 15G platforms (But there are bugs fixed in the later releases that probably would be nice to have. A01 no errors are printed and the disks are found just fine. A04 it gives a couple of errors at kernel boot time, but does detect the disks and the system boots. (We have two M.2 SSDs connected to that controller) A05) does something strange - when the kernel has loaded (from the drives on this card) it fails to detect the disks ("unconfigured" disks, non-RAID setup) and then root fs mounting fails. (Probably not meaningful to try to report it to Dell since FreeBSD isn't officially supported by them)ĭell BOSS-S1 (Marvell 88SE9230 based) M.2 "RAID" cards running Dells latest firmware (2. This feels more like a firmware problem than a driver problem but since it apparently works in Windows and Linux, but not in FreeBSD I figured I'd report it here anyway. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |